[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

(ET) Tuesday Night in Michigan



Here is where I stopped on Tuesday night. Three screws remain to be drilled out tomorrow then I can finish prepping the steel for primer, then color hopefully this weekend.
Looks like a few wires and this entire electrical section can be 
removed, after carefully marking the wires. Someone drilled two holes in 
the right side panel so I'm taking that into work tomorrow and welding 
the holes back shut, grinding and then prime/paint. The pin holding the 
brake pedal is ALMOST out but I just can't seem to budge it that last 
fraction of an inch,  gave up on it for tonight. Need to remove the 
steering wheel so I can get the plastic dash out, that might be fun. 
Continue stripping paint, clean, primer and then the painting begins.
Not touching the underneath portions this time, maybe a good fall/winter 
project.
The winch assembly looks messed with, doesn't look right, may tear into 
it, even though it seemed to work. Any PM recommended, white lithium on 
the gears perhaps?
Still looking for a seat bottom, either the entire seat cushion assembly 
OR the steel pan that is attached to the foam pad. It has a plastic 
edging on it and two nuts are welded to it. The steel pan is glued to 
the seat cover, I need that steel bottom piece, or a nice seat bottom 
complete.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://cosmos.phy.tufts.edu/mhonarc/elec-trak/attachments/20240522/3eb9724d/attachment.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: 39f2709e.png
Type: image/png
Size: 1541263 bytes
Desc: not available
URL: 
<http://cosmos.phy.tufts.edu/mhonarc/elec-trak/attachments/20240522/3eb9724d/attachment.png>