[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: (ET) start



I'd suggest getting the ET manual from Mr. Gunn. It's worth every penny you
will spend.

Regardless, the E12 is a very simple version of the E20. No field weakening
(though what is that power pulse switch?) and only two relays, 1RTN and
2RTN. Since 1RTN is always used as the latch for the PTO, my guess is the
contacts on the 2RTN relay (the one that requires the speed lever to be
moved to neutral then speed in order to restart the tractor in the event of
a seat/brake interrupt) is in need of cleaning, or is misaligned.

Since there is no FW circuit, Fwd/reverse is simply wired directly to the
1f-2f/1r/2r coil sets.

Looks like "power pulse" button temp bypasses the centrifugal switch. 
Anyone
know what that is and why that is in there? All I can see the cent switch
doing is opening the 2A coil, and putting a resistor in series with the
motor.

Odd.

Chris


----- Original Message -----
From: "Neil Dennis" <wombat RealNS com>
To: "Elec-trak" <elec-trak cosmos phy tufts edu>
Sent: Tuesday, April 16, 2002 4:42 PM
Subject: (ET) start


> No, it's an E-12 and has a few problems with relays overe the 15 yrs
> I've had it.  Biggest problem has been with square ended microswitches
> on speed control causing hard or sticky operation until I got smart and
> radiused the operating buttons.
>
> BTW, when I'm tilling, the load meter is usually in the yellow or red.
> And that's after I recalibrated the shunt (made it the correct length as
> it was too long so always read higher than it should.
>
> wombat
>
>
>